Troubleshooting
7.4
10 Module Variance Too High Contact Zero or your dealer.
11 Battery Temperature Sensor Fault Motorcycle will run, but needs service. Contact
your dealer.
12 Welded Contactor Contact Zero or your dealer.
13 Motor Controller Error Motorcycle needs service. Contact Zero or your
dealer.
14 Loopback Error Needs second module, or blanking plug
inserted.
15 Battery Management System (BMS)
Startup Error
Reset BMS with button. If problem persists
contact Zero or your dealer.
16 Battery Management System (BMS)
Internal Disable
Cycle Ignition Key OFF and then ON again, or
reset BMS with button. If problem persists
contact Zero or your dealer.
17 Battery Management System (BMS)
Internal Fault
Cycle Ignition Key OFF and then ON again, or
reset BMS with button. If problem persists
contact Zero or your dealer.
18 Miscellaneous Error Contact Zero or your dealer.
NUMBER OF RED FLASHES CAUSE SOLUTION
Zero Owner's Manual (S and DS).book Page 4 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
