General Maintenance
6.11
Rear Brake Fluid Reservoir
The reservoir is located inboard on the frame behind the heel
guard.
Note: The motorcycle should be in an upright position prior to
checking fluid level.
Inspect the level of the rear brake fluid through the reservoir
housing. If the fluid level is visibly below the low minimum
LOWER indicator (C), brake fluid must be added until level
reaches the upper UPPER indicator (B). Do not overfill.
Clean any dirt or debris from the cap and reservoir opening (A)
before opening the reservoir.
Unscrew the cap and add new DOT 4 brake fluid. Inspect the
cap seal ensuring that it is free of any wear or damage then
reinstall the cap.
Zero Owner's Manual (S and DS).book Page 11 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
