LINEUP ASSEMBLY
On Outside Of Case
Plate Located Below End
Remove End Protection
Caulk Here
Caulk Here
B
APPROVED INSTALLATION
9651
UPDATE CASE VIEW
(PER SP-0457)
RELEASED
TOLERANCES:
(IN LBS)
PART WEIGHT:
NO MANUAL REVISIONS
CAD DRAWING
9/13/2012 JZ
No.
SP-6005-2
(NONE)
CONSENT OF ZERO ZONE, INC. IS STRICTLY PROHIBITED.
(NONE)
REPRODUCTION OR OTHER MEANS, WITHOUT THE WRITTEN
(PER SP-0154)
FINISH:
(PER SP-0404)
(UNLESS OTHERWISE SPECIFIED)
A
MATERIAL:
SIZE
(NONE)
JZ
SCALE:
MODELED BY:
DRAWN BY:
SHEET
DOCUMENT OR DISCLOSURE OF ITS CONTENTS; BY
NOT TO SCALE
ARE IN DECIMAL INCH
9/13/2012
B
1 OF 1
SEALING REQUIRED FOR NSF
SHEET:DATE:
REVISION
ZERO ZONE, INC.
SPECIFIED, ALL DIMENSIONS
UNLESS OTHERWISE
USA 53153
DRAWING No:
DESCRIPTION:
BY
DATE
ECN No.
REVISION DESCRIPTION
COPYRIGHT INFORMATION
THIS DRAWING AND THE INFORMATION CONTAINED WITHIN, IS
THE SOLE PROPERTY OF ZERO ZONE, INC. ANY USE OF THIS
110 NORTH OAKRIDGE DRIVE
NORTH PRAIRIE, WISCONSIN
REVISION INFORMATION
DWG NO.SP-6005-2REV. B
SURFACE TEMPERATURE SHOULD BE ABOVE
40°F AND FREE OF FROST.
1. Apply nonporous/nonabsorbent good quality NSF
approved silicon caulk sealant or (Manus Bond
75-AM) after end panel is joined to case or when
second case is joined with rst case.
2. Apply silicon caulk-sealant bead to areas shown
to meet sealant requirements for NSF approved
installations.
3. Apply small beads of sealant smoothly, but do not
thin or feather excessively, because it may affect
adhesion.
NOTE: Field caulk is applied continuously.
A
Typ (5) Places
DETAIL A
1
2
2
3
End frames factory installed.
Exploded for clarity.
4
5
Joining Frames
Typ (4) Places
DWG NO. SP-0537 REV.H
Joining 24" & 30" Cases
Caulk Case Joints
Per I&O Manual
NOTES:
PAPER TO BE 20 POUND, COLOR GREEN.
1.
A .PDF COPY OF THIS LABEL IS AVAILABLE.
2.
LABEL IS DRAWN ACTUAL SIZE.
3.
4.250
5.500
.125
TOLERANCES:
(PER SP-0457)
(NONE)
RELEASED
PART WEIGHT:
(IN LBS)
CAD DRAWING
NO MANUAL REVISIONS
COPYRIGHT INFORMATION
THIS DRAWING AND THE INFORMATION CONTAINED WITHIN, IS
THE SOLE PROPERTY OF ZERO ZONE, INC. ANY USE OF THIS
DOCUMENT OR DISCLOSURE OF ITS CONTENTS; BY
REPRODUCTION OR OTHER MEANS, WITHOUT THE WRITTEN
CONSENT OF ZERO ZONE, INC. IS STRICTLY PROHIBITED.
(NONE)
(NONE)
FINISH:
(PER SP-0154)
MATERIAL:
(PER SP-0404)
(UNLESS OTHERWISE SPECIFIED)
A
SHEET
SIZE
NOT TO SCALE
JZ
SCALE:
MODELED BY:
DRAWN BY:
UNLESS OTHERWISE
SPECIFIED, ALL DIMENSIONS
ARE IN DECIMAL INCH
9/14/2012
H
1 OF 1
SP-0537
LABEL 24" & 30" CASE JOINING
SHEET:
DATE:
REVISION
ZERO ZONE, INC.
110 NORTH OAKRIDGE DRIVE
NORTH PRAIRIE, WISCONSIN
USA 53153
DRAWING No:
DESCRIPTION:
BY
DATE
ECN No.
REVISION DESCRIPTION
No.
JZ
10/16/2012
9712
REDRAWN, UPDATED TITLE, SHIM DESC.
H
REVISION INFORMATION
2" X 6" WAS 2" X 5", 41-0166 WAS 41-0133
Figure 10: Required Sealing for NSF-Approved Installations
Figure 11: T-Strips Figure 12: Joining 24" and 30" Door Cases
Lineup Assembly • 13
To Next Page
Loading...
