105
DRIVE OF AGRICULTURAL MACHINERY
Before connecting the machinery
driven by PTO shaft, check that
the revolutions of PTO shaft of the
machinery and the tractor comply
(540 or 1000). Different revolu-
tions may lead to serious damage
and injuries.
Page
Work with PTO shaft ............................................................................................... 106
Front and rear PTO shaft control ............................................................................. 107
Rear pto shaft revolutions preselection lever .......................................................... 108
Standard and economical Independent revolutions of rear PTO shaft .................... 109
Dependent and independent rear pto shaft revolutions ........................................... 110
Facilitating connection of joint shaft of an aggregated machine to the tractor ......... 111
Rate preselection switch of starting rear PTO shaft ................................................ 112
Selection switch of rear PTO clutch revolutions (P.T.O.) ......................................... 113
Replaceable end points of rear PTO shaft .............................................................. 113
Rear PTO switch ..................................................................................................... 114
Engaging rear PTO shaft - INdependent revolutions .............................................. 115
engagement of rear pto shaft - dependent revolutions ............................................ 116
Automatic disengagement of PTO clutch ................................................................ 117
Setting automatic disengagement of PTO shaft clutch - display description ........... 118
Automatic disengagement of PTO shaft clutch – return to basic setting ................. 118
Setting automatic disengagement of PTO shaft clutch ............................................ 119
Work with automatic disengagement of PTO shaft clutch ....................................... 120
Front PTO shaft ....................................................................................................... 121
Front PTO shaft control ........................................................................................... 121
Maximum transferred output ................................................................................... 122
Drive of machines with greater inertia masses ........................................................ 122
To Next Page
Loading...
