5
Preparing and Charging the Batteries
Charging Procedure
1. Insert the batteries into the charger in the right direction (positive/negative end)
accordingly.
2. Connect the charger to the adapter via the USB Type-C cable.
3. Plug the adapter into a power outlet to start charging.
① Due to the differences of the charger itself, charging the batteries may fail when
the power supply is insufficient (for instance, when the current of the adapter is
lower than 500mA). Conditions may vary depending on the specific chargers
used. It is recommended to use an adapter with a higher current capacity.
② The battery cannot be charged through the USB port on the stabilizer.
① Please use a qualified standard 5V/ ≥ 2000mA adapter for battery charging;
charging time depends on the maximum input current of the adapter.
② This stabilizer comes standard with three high-discharge-rate ZHIYUN batteries.
Use only ZHIYUN batteries or ZHIYUN-approved batteries.
③ Please make sure the three batteries are fully charged. Undercharged batteries
can cause stabilizer malfunction.
USB Cable Adapter Power
Supply
To Next Page
Loading...
Need help?
General
