!"#$%&'()*"+*,-. !"#$%&'()*"+*,-
bottom of the Mounting Plate, so that it can
slide forward or backward.
Choose any slot to insert the Camera Mounting
Screw according to the camera position, and0.
tighten up to fix the camera position.
Push the camera forward or backward to find its
level balance. Once the camera can stay still and
almost level with its lens facing front, complete
this step by tightening up the Camera Mounting
Firstly, loosen Thumb Screw (rotate for 3
times). 2 Adjust the Tilt Axis until the camera can
stay still with the lens facing up (i.e. the camera
stays still and vertical to the ground), complete
this step by tightening up Thumb Screw .2
Balance Adjustment on Roll Axis
To Next Page
Loading...
