Zhiyun CRANE - How to Start up

!"#$%&'()*"+*,-. !"#$%&'()*"+*,-
62
63
. Start Up Start Up
Control Panel Introduction
Power ON/OFF
Power on the stabilizer by pressing the Power button for about 3 sec. After the stabilizer is
powered on, the Power button can be used for camera shooting control (only after the
camera is connected to the stabilizer).
Single press the button to take photos.
Double press the button to start video recording. Double press the button again to stop recording.
Battery Level Indicator
Shines YELLOW light when the stabilizer is powered on/off:
Quick flash for 3 sec. and shines solid for 1 sec. when powered on. Quick flash for 3 sec. when
powered off.
Shines BLUE light when the stabilizer is in normal operation, the flashing frequency of the BLUE
light indicates the current battery level:
Quick flash 4 times for battery level of 76%-100%.
Quick flash 3 times for battery level of 51%-75%.
Quick flash 2 times for battery level of 26%-50%. Quick flash
1 time for battery level of 1%-25%.
64
How to Start Up