!"#$%&'()*"+*,-. !"#$%&'()*"+*,-
See ZHIYUN's product training videos on
www.ZHIYUN-TECH.com for more operation tips.
Pan Following Mode: The camera
pans left/right
following the movement of the
stabilizer while the tilt and roll
axes are locked. Push the
joystick up/down allows
manual control of the tilt axis.
Locking Mode: This mode
locks movement of all three
axes to keep the camera still
and stable. Push the joystick
up/down and left/right allows
manual control of the tilt axis
Following Mode: The camera
pans and tilts following the
movement of the stabilizer.
Push the joystick left/right
allows manual control of the
roll axis.
Quick press MODE (Joystick) three times and the camera will turn 180° along the pan axis while
the active control mode remains unchanged.
/7
Initializing the Stabilizer
Initialize the stabilizer under the following circumstances:
① Slight deviation is found in the tilt angle of the camera in level position after startup.
②Slight deviation is found in the roll angle of the camera in level position after startup.
③Frequent small angle correction is found when the camera is in level position while the
stabilizer stays still.
1.Install the batteries properly.
2.Hold the camera mounting plate and long press the Power Button to turn on the stabilizer. The
motor will generate acting force upon activation, hold the camera mounting plate still, and long
press the Mode Button to enter standby mode.
3.Put the stabilizer still on a table surface, wait for about 10 sec., and the stabilizer will automatically
complete initialization.
If slight deviation can still be found after initialization, repeat the procedure above to initialize
again.
/6
To Next Page
Loading...
