29
Calibration and Firmware Upgrade
When to Calibrate the Stabilizer
Please calibrate the stabilizer when necessary.
Calibration Reason How to
calibrate
1. Slight deviation is found in the level position after the initialization of the
stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature difference in operation
Environments.
Six-side
calibration
Slight deviation is found in the tilt or roll angle of the camera in level
position after initialization and six-side calibration of the stabilizer.
Motor fine-
tuning
Six-side Calibration
1. Six-side calibration via APP：
According to the method introduced in "How to Use the App", please connect the
stabilizer to the APP, and enter "Settings"- "Six-side Calibration", then conduct the
six-side calibration according to the prompt.
2. Six-side calibration via "Zhiyun Gimbal Tools":
Power on the stabilizer and enter standby mode. Connect the charging/upgrade port
of the stabilizer to the computer with the Type-C USB cable, Open "Zhiyun Gimbal
Tools", click "open" on the top and click "calibration" on the bottom. Please conduct
the process according to the following steps. A " √ " mark will appear after the
calibration is completed.
Notes:
① Please refer to the six-side calibration steps below. After the calibration is
completed, please restart the stabilizer.
② In simple terms, six-side calibration is to place all six sides of the camera
mounting plate in vertical to a level surface respectively.
To Next Page
Loading...
Need help?
General
