Zhiyun WEEBILL 2 User Manual

23
How to Use WEEBILL 2
Use with TransMount Image Transmission Transmitter AI (hereinafter
referred to as "transmitter AI")
Install
1. Take out the transmitter mounting plate, mount the transmitter mounting plate to
the bottom of the WEEBILL 2's level mount (note the direction of the notch), and
use the wrench to tighten the screws.
2. Place the transmitter AI with the mounting plate slot facing up, align the transmitter
mounting plate, push the transmitter AI toward the tilt axis motor until it clicks into
the safety lock to make sure a firm installation.
In order to have the best image transmission, please rotate the antenna to the
position as shown in the image.

Zhiyun WEEBILL 2 Specifications

General

Operating Voltage	7.4 V
Payload Capacity	3.3 kg
Battery Runtime	9 hours
Charging Time	Approximately 1.6 hours with a 24W charger
Stabilization	3-axis
Connectivity	Bluetooth 5.0, USB-C
Weight	1.47 kg
Battery Capacity	2600 mAh
Compatible Cameras	DSLRs and mirrorless cameras
Control Interface	Touchscreen, buttons
Follow Modes	Pan Follow, Lock, POV, Vortex, Go
Gimbal Type	3-axis handheld gimbal