Zibro Laser FF 95 - Inner Flue Pipe Installation

Chapter 1, INSTALLATION
35
I
nner fiue pipe
Wood screws
Arrow
inside Outsida
230~320mm
2˚ downward Min.

Fig. 7
Outer flue pipe
Exhaust joint
Intake joint

Fig. 8
3. Install the inner flue pipe.
a. For wall thickness 230~320mm.
F
rom inside the room, insert the inner flue pipe through the hole. Make sure the arrow on the inner flue
pipe is pointing up. Secure the inner flue pipe to the wall with the three wood screws. (See Fig. 7)
b. For wall thickness 130~230mm.
Remove Intake joint and Exhaust joint from Outer flue pipe (See Fig. 8).
Outside
I
nside