Zimmer Cryo Mini - Power Connection and Operation

Device Set Up
6
Page 9
Assemble castor
guards
The castor guards are plugged onto the castor holders.
Connect power cord
Connect the power cord to the designated port (11) of the device and connect it to the
mains.
Note:
The device may only be connected to sockets with protective earth.
Caution !
After transport or assembly work in a horizontal position, CryoMini must stand upright
for at least 30 minutes before switching on.
The compressor may otherwise be damaged.
Turn the device on
The device is switched on using the toggle switch (10).
Turn the device off
The device is switched off using the toggle switch (10).
To disconnect the device completely (all-pole) from the mains, unplug the power cord.
Caution !
All cables must be protected from pinching or other mechanical damage.