4
MICROCHOICE
™
CONTROLLER
The Hall
®
MicroChoice
Controller is designed and manufactured
specifically to power only
MicroChoice
and levered Micro E
®
handpieces.
The
MicroChoice
Controller is designed to operate on grounded electrical
power.
Important Note: The Controller will not detect improper grounding
between itself and the electrical outlet. Proper procedures must be
followed to assure proper grounding of the Controller.
The system is designed to meet standard electrical safety requirements for
surgical instruments that are likely to be applied to a patient in a health care
facility.
Notes: The
MicroChoice
Controller is designed with "closed loop
feedback". This design provides immediate electronic feedback to hold
handpiece speed constant even with increasing load. Caution should be
exercised while becoming familiar with the operation of the
MicroChoice
system.
Each
MicroChoice
Controller is shipped from the factory pre-set to your
power requirements. See page 61, Technical Specifications, for
information regarding fuses and selecting voltage options.
PRIOR TO PUTTING THE SYSTEM INTO USE, REFER TO THE
“RECEIVING/PERIODIC INSPECTION” SECTION ON PAGE 64
FOR IMPORTANT INFORMATION
To Next Page
Loading...
