To Next PageTo Next PageWhat to do if my Zip Water Heater shows error E44?
If your Zip Water Heater displays the E44 error, it means the heater needs to be filled with water. You can resolve this by filling the heater with water. The error can be cleared by switching off the heater or by holding button 2 for 3 seconds.
What to do if my Zip Aquapoint AP430S SmartEco Water Heater displays error E5?
If your Zip Water Heater displays the E5 error, it should automatically clear once the temperature drops below the set value. However, if the error persists, it is recommended to call the service company.
General| Model | AP430S SmartEco |
|---|---|
| Capacity | 30 Litres |
| Temperature Control | Adjustable Thermostat |
| Warranty | 2 Years |
| ErP Rating | A |
| Energy Efficiency Class | A |
| Frequency | 50 Hz |
| Protection | IPX4 |
| Heating Element | Copper |
| Mounting | Wall Mounted |
| Recovery Time | Not applicable |
| Voltage | 230-240 V |
Compliance with LVD, EMC directives, and CE marking.
Potentially hazardous situations leading to death, injury, or damage.
Potentially hazardous situations leading to property damage.
List of items included in the installation kits.
Physical dimensions and installation diagrams for the heater.
Instructions for connecting the water inlet and outlet, including safety valve requirements.
Schematic diagram for closed pressure system pipe fitting.
Procedures for connecting the heater to the mains electrical supply.
Diagram illustrating the internal electrical circuit of the heater.
Guidelines and diagrams for installing the discharge pipe from safety valves.
Explanation of the control panel buttons, display, and indicators.
Instructions for setting and adjusting water temperature manually.
Guide to using the energy-saving SmartEco mode and its recording feature.
Advice on cleaning, servicing, and anode inspection for durability.
Steps to safely drain water from the heater for maintenance or disconnection.
Identification and resolution of error codes displayed by the heater.
