Why is my Zip Econoboil 5L water not boiling?
If your Zip Boiler is not boiling water, first verify the power supply is working. The issue might stem from a faulty PCB, element, or cut-out. If the problem persists, it is advisable to contact a Zip authorized agent for assistance.
What to do if my Zip Boiler fails to dispense water?
If your Zip Boiler fails to dispense water, check if the water supply valve is turned off. A blocked filter, meter tube, strainer, jammed ball valve assembly, or an airlock in the transfer tube could also be the cause. For further assistance, it is recommended to contact a Zip authorized agent.
Guidance on safe use by children and persons with reduced capabilities, emphasizing supervision.
Requirement for qualified technicians for cable replacement and installation procedures.
Instructions for safe discharge of steam and boiling water from the vent outlet.
Ensuring the appliance is installed upright and on a horizontal base in an accessible area.
Specifies minimum clearance dimensions (≥ 65mm/≥ 150mm) around the appliance for service access.
Testing earthing continuity using a resistance meter (< 1.0 Ω) with power OFF.
Activating electrical power to commence boiling calibration and allowing time for heating.
To Next Page
General