Page 14 of 20 804050UK G4 Commercial chilled and sparkling installation instructions - Sept. 2016 - v3.02
After replacing a cylinder or after making a
gas connection, perform a leak test to check for
gas leaks between regulator and cylinder, and between regulator
and braided hose.
Stage 1
1. Turn the gas off.
2. Using soapy water applied with a sponge, or with a
brush, cover all of the gas joints with a liberal
amount of suds.
Stage 2
1. Turn the gas on.
2. Inspect the joints for leaks.
3. If any bubbles appear to grow, the joint will need to be
resealed and tested again.
CO2 Regulator
Leak Test
Note When removing hose, take care not to
lose plastic olive from the fitting.
3.1 Braided hose fitting
Install the mains water braided hoses to the Command-Centre
TM
before locating in place.
Section 3
Command-Centre
TM
installation
Test for leaks at these two points
To Next Page
Loading...
