To Next PageTo Next Page
What causes condenser overtemp in Zip HydroTap G4 Water System?
If the condenser of your Zip Water System is experiencing overtemperature, this is likely due to a blocked air filter. Remove any blockage and clean the filter. Refer to the user guide for detailed instructions.
What to do if boil dry protection is activated on my Zip Water System?
If the boil dry protection is activated on your Zip Water System, turn the power OFF and then ON again to reset it. This is usually triggered by a safety mechanism.
Why is the compressor over-running on my Zip Water Filtration Systems?
If your Zip Water Filtration System's compressor is over-running, this could be because the compressor is too hot. Ensure that the unit has adequate ventilation.
How to troubleshoot a power board fault in Zip Water Filtration Systems?
If your Zip Water Filtration System displays a power board fault, the issue might stem from an electrical disruption. To address this, check the power supply and all fuses connected to the system.
What to do if the boil dry protection is activated in Zip Water Filtration Systems?
If your Zip Water Filtration System's boil dry protection has activated, it's likely due to the safety mechanism being triggered. To reset, turn the power OFF and then ON again.
What to do if the water supply failed on my Zip Water Filtration Systems?
If your Zip Water Filtration System is experiencing a water supply failure, it's likely due to the water supply not being turned ON. Ensure that the water supply is turned ON.
What to do if there is a water leak in my Zip Water Filtration System?
If your Zip Water Filtration System experiences a water leak, immediately turn off the mains water supply and call for service.
What to do if my Zip Water Filtration System has a water supply failure?
If you are experiencing a Water Supply Failure with your Zip Water Filtration System, the first thing you should do is check that the water supply is turned ON.
What to do if the boil dry protection is activated on my Zip Water Filtration System?
If your Zip Water Filtration System has tripped the boil dry protection, which was activated for safety reasons, turn the power OFF and then ON to reset the system.
What to do if there is a water leak in my Zip Water Filtration Systems?
If you notice a water leak in your Zip Water Filtration System, immediately turn off the mains water supply to prevent further leakage and then call for service.
General| Model | HydroTap G4 |
|---|---|
| Category | Water System |
| Power Supply | 220-240V, 50Hz |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Boiling Water Capacity | Up to 160 cups per hour |
| Filter | Advanced filtration system |
| Safety | Child safety lock |
| Filtration | 0.2 micron |
| Energy Efficiency | Energy-saving mode |
| Warranty | 5 years |
| Chilled Water Capacity | Varies by model (e.g., up to 175 cups/hour) |
