Zip HydroTap G5 BC100 - Page 26

26
Quick Start Installation Guide
807118UK v1.12 12.23 G5 BC Quick Start Guide
12.3 Install the filter cartridge
• Unpack filter cartridge.
• Remove dust cap and set aside in a clean area
for use later.
SECTION 12: Commissioning
• Write today’s date where shown on the label.
• Avoid touching the filter o-rings and
filter opening as this may cause bacterial
contamination of the cartridge.
• Moisten the o-rings with water.
• Open the filter door on the Command Centre.
• Push the new cartridge up into the filter head.
• Turn the cartridge a quarter turn to the right
until it comes to a complete stop and locks.
12.4 Set the date, time & drain away options
DATE & TIME 10:50
2021
Dec
06
10
50
:
24 hr
Time
• Touch the date and time, use "-" or "+" to
make adjustments. When ready, touch
the arrow to continue.
9:26DRAIN AWAY OPTION
Does your tap drain into a:
Or
Sink/Container Font
If you are not clear on your selection options
refer to the commissioning instructions.
• Select 'Sink / Container' or 'Font'
depending on the model , see below.
• Select 'Font' if the HydroTap is mounted
on a font.
• Select 'Sink / Container' if the HydroTap
is mounted such that the waste water
dispenses into a sink, or container.
• Note This selection
will determine if
water is dispensed
automatically or
requires operation
of the tap during the
tank flush process.
• Touch the arrow to
continue.
Font
Sink
Container