Zip HydroTap G5 BC100 - Page 28

28
Quick Start Installation Guide
807118UK v1.12 12.23 G5 BC Quick Start Guide
SECTION 12: Commissioning
12.5.1 Limescale filter flush
• Disconnect the limescale filter OUT hose
from the Command Centre manifold.
• Direct it into a sink or suitable container.
• Touch green play icon to start filter flush.
12:12 PMLIMESCALE FILTER FLUSH
Step 1.
Disconnect the limescale filter OUT hose
from the manifold inlet.
Step 2.
Place a 15L container under the hose to catch
the water flushed through the filter.
12:12
| |
LIMESCALE FILTER FLUSH
RUNNING.....
Water is now being flushed through the filter.
This process is automatic and will take 7 minutes.
Press pause to pause filter flush.
LIMESCALE FILTER OPTION 12:12 PM
Do you have a limescale filter installed
with your HydroTap ?
NO YES
12:12 PMLIMESCALE FILTER FLUSH
LIMESCALE FILTER HAS BEEN FLUSHED!
Reconnect the limescale filter hose to the manifold.
• Once the filter flush is finished, reconnect
the limescale filter OUT hose to the
Command Centre manifold.
• Touch the arrow to go to the next screen.
• Follow the steps on-screen.
• (Selecting NO advances the screen to the next process).
(If optional limescale filter is installed)
IN
OUT
IN OUT
IN OUT