Zip HydroTap G5 BC100 - Page 33

Quick Start Installation Guide
807118UK v1.12 12.23 G5 BC Quick Start Guide
33
SECTION 12: Commissioning
• Read the on screen information and
instructions.
• Note When the cleaning process
completes there is an opportunity to
re-install the filter while the boiling
calibration is finishing.
RE-INSTALL FILTER 12:12 PM
Step 1.
While Boiling Calibration in Progress....
Step 2.
Ensure cloth is below HydroTap Clean can (2).
Remove can (2) from HydroTap Clean adapter (1).
RE-INSTALL FILTER
12:12 PM
Step 1.
If the below steps have not been completed.
Follow the instructions below.
Step 2.
Ensure cloth is below HydroTap Clean can (2).
Remove can (2) from HydroTap Clean adapter (1).
• Unscrew the HydroTap Clean can (2).
• Ensure to hold the adapter in place while
unscrewing the can.
• This screen is shown after completion of
the boiling calibration and or cleaning
processes.
RE-INSTALL FILTER 12:12 PM
Step 3.
While Boiling Calibration in Progress....
Step 4.
Remove adaptor (1) from filter head.
Re-install filter. Dry any water under filter.
RE-INSTALL FILTER
12:12 PM
Step 3.
If the below steps have not been completed.
Follow the instructions below.
Step 4.
Remove adapter (1) from filter head.
Re-install filter. Dry any water under filter.