EasyManua.ls Logo

Zip Tudor User Manual

Zip Tudor
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Page 1 Zip Tudor - Installation & Operating Instructions - 81333 - February 2010 V2
Section Heading
Zip Tudor
Single point open outlet (vented) water heaters
21051 Zip Tudor 5 Litre over-sink water heater
21052 Zip Tudor 5 Litre under-sink water heater
21101 Zip Tudor 10 Litre over-sink water heater
21102 Zip Tudor 10 Litre under-sink water heater
99032 Telescopic Spout accessory for 21051 / 21101 (320mm-720mm)
99076 Mono vented mixer tap for 21052 / 21102
99075 Solo vented mixer tap for 21052 / 21102
99051 Hero vented mixer tap for 21052 / 21102
Installation & Operating Instructions
Mono*
Solo*
Hero*
Accessory Tapware for
Under-Sink Tudors.
Above-Sink Tudor
(No tapware included)
Under-Sink Tudor
* Accessory Tapware as indicated sold separately.

Questions and Answers:

Zip Tudor Specifications

General IconGeneral
BrandZip
ModelTudor
CategoryWater Heater
LanguageEnglish

Summary

Read These Warnings First

Installation Requirements

Installation Procedure

Step One - Tapware

Details installation of tapware, including inlet valve and Restrictaflow for over-sink and under-sink models.

Step Two - Positioning

Guidelines for heater placement, ensuring adequate clearance for service access.

Step Three - Fastening

Instructions for securely mounting the heater to the wall using appropriate fixing screws.

Step Four - Connecting

Describes connecting water supply and power, noting inlet/outlet locations for different models.

Step Five - Commissioning

Outlines the process of filling the heater, purging air, and turning on power.

Retrofit Instructions for Open Vented Heaters

Guidance for retrofitting, emphasizing the Restrictaflow valve and tapware compatibility.

Operating Procedures

Control Panel

Overview of the heater's control panel and its components.

Water Temperature

Explains how to adjust water temperature and recommended settings.

Economy Setting

Details the 'E' setting for maintaining water temperature at approximately 60°C.

Frost Protection

Describes the 'anti-freeze' setting to prevent damage in cold conditions.

Safety Cutout

Explains the function of the manual safety cutout and who should reset it.

Cleaning

Provides instructions on how to clean the heater's outer surfaces safely and effectively.

Service Procedures

Removing the Case

Step-by-step guide on how to safely remove the heater's outer casing.

Replacing a Thermostat

Detailed instructions for replacing the thermostat, including electrical connections.

Tap Temperature Adjustment

Information on adjusting tap temperature limiters for specific tap models.

Problem Solving

Warranty Information

Related product manuals