Need help?Do you have a question about the Zipato Zipabox and is the answer not in the manual?
General| Operating System | Linux |
|---|---|
| Operating Temperature | 0°C to 40°C |
| Connectivity | Ethernet, Wi-Fi |
| Compatibility | Z-Wave, ZigBee, Bluetooth, 433MHz |
| Power Supply | 12V DC |
| CPU | ARM Cortex-A8 1GHz |
| Wireless Technology | Wi-Fi 802.11 b/g/n, Bluetooth 4.0 |
Connect your Zipabox to your broadband router via the Ethernet cable.
Set up your Zipato account and register your Zipabox to benefit from the monitoring service.
Enter the serial number of your Zipabox when you first log into your account.
Drill holes in the wall surface and hook the Zipabox onto screw heads for mounting.
Hook upper fitters on the back of your Zipabox to the Din rail and press to snap lower fitters.
Place your Zipabox on any table top, ensuring the swivel antenna is vertical.
Bring device closer to Zipabox and follow inclusion/join mode instructions for adding.
Covers CPU, RAM, Flash, network interfaces, and operating system information.
To Next Page
