Zippity Baskenridge - General Assembly Advice; Preparation and Installation Guidance

WWW.ZIPPITY-OUTDOOR.COM
3
ASSEMBLY INSTRUCTIONS
ZP19038





understand your fence.



install your gate posts before you do anything else.

of fence that is connected to another post. This way, the weight strain will be trans-
ferred onto two posts versus just one. Installing fence panels on both sides of your



your gate correctly, please disassemble as necessary, and use the provided self-drilling
stainless steel screws to permanently assemble the gate.
1. That you have everything necessary to complete the gate.
2. That you will have assembled the gate frame in the correct order.
3. All of the pieces t and funcon properly.
4. The gate height and width are similar to the measurements shown on page four.
GENERAL INFORMATION

Use joiner clips (included in ZP19037) to
aach the gate to the fence panels.