- 31 -
Click the draw-down box to
select the Authentication Type
Step 8.Select Encrypt Type
When the item NONE of encrypt Type is selected, then the
password in WEP (Wired equivalent privacy) and WPA (WiFi
protested access) item is not permitted to modify it, it is not need to
input password too.
According to Authentication Type, and Encrypt Type ,Click draw
down box
to input the
password, password comply with the criterion set down by the
software.
Note: there are four group passwords in the WEP column, till the
all password have been set up is correct, the current password is
valid
Step 9Set Connection Parameter
The fingerprint machine fully support two connection ways, one
TCP/IP, anther one is RS 232,.
If you select TCP/IP, here the IP and Port value must to be assigned,
its value is same with one in the communication option of the
fingerprint machine. Set the option Ethernet in the fingerprint
machine to “Yes”.
If you selectRS232, must configure these parameter ,DeviceID、
COMPort、Baud rate same with one in the communication option
of the fingerprint machine.
To Next Page
Loading...