Need help?Do you have a question about the ZKaccess C3-200 and is the answer not in the manual?
Lists optional accessories for the access control panel.
Explains the meaning of various LED indicators on the access control panel.
Instructions for connecting the C3-200 directly to a PC using a network cable.
Best practices and common mistakes for setting up RS485 networking.
How to set the device number for RS485 communication using DIP switches.
Steps to reset the C3-200 to its default factory settings.
Configuration of RS485 termination resistance using DIP switch number 8.
A table detailing PC RS485 address and switch settings.
General| Model | C3-200 |
|---|---|
| Device Type | Control Panel |
| Number of Doors Controlled | 2 |
| Number of Readers Supported | 4 |
| Communication | TCP/IP, RS485 |
| Operating System | Embedded Linux |
| User Capacity | 30, 000 |
| Fingerprint Capacity | 10, 000 |
| Card Holders | 30, 000 |
| Record Capacity | 100, 000 |
| Input Voltage | 12V DC |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 20% ~ 80% |
To Next Page
