C2-260/inBio2-260 Access Control Panel
User Manual
Page | 31 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
New Server Address: To add a device by IP Address or Domain Address, devices can be added to the
software by entering the domain address.
New Server Port: Set the access point of the system.
DNS: Set a DNS address of the server.
Clear Data in the Device when Adding: If this option is selected, then after adding a device, the system
will clear all data in the device (except the event logs). If you add the device merely for demonstration or
testing, there is no need to select it.
To Next Page
