C2-260/inBio2-260 Access Control Panel
User Manual
Page | 32 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Note: When using either of the above three device adding methods, if there exists a residual data in the
original device, please sync the original data to it after adding a new device to the software by clicking
Device > Synchronize All Data to Devices, otherwise, these original data may conflict with normal
usage.
5. The default IP address of the access device may conflict with the IP of a device on the local network.
You can modify its IP address: click Modify IP Address, and a dialog box will pop up in the
interface. Enter the new IP address and other parameters (Note: Configure the gateway and IP
address in the same network segment).
Note: Some PUSH devices support SSL. To use this function, select the HTTPS port during software
installation and ensure that the device firmware supports SSL.
To Next Page
