Inflating the ERB
Unroll your ERB onto a flat surface making sure that there are no sharp stones or debris underneath
the boat.
Insert the end of the hose firmly into the valve on the boat.
NOTE
The diaphragm inside the manual inflation valves must be in the closed position (inflation position –
see manual) prior to inflating, otherwise the air will escape through the open valve once the air line is
removed.
NOTICE
Ensure that the inflation hose is inserted into the inflation valve and not the
pressure relief valve as this could cause severe damage. The inflation valve
is the one with the flat screw-on cap.
Once the inflation hose has been inserted into the valve on the boat, the valve located on top of the
cylinder can be opened and the boat will start to inflate (see instruction manual on correct inflation of
the buoyancy tubes)
To Next Page
Loading...
