Zodiac TRi pH Module - 1 Information before Installation; General Delivery Conditions; Contents; Technical Specifications

H0412500.A - EN - 2013-02
3
1. Informaon before installaon
1.1 General delivery condions
All equipment, even carriage and packaging paid, is shipped at the recipient's risk. If damaged caused during transport
is observed, the recipient should write appropriate comments on the delivery note provided by the carrier (and con-
rmed in wring to the carrier by registered leer).
1.2 Contents
1.2.1 TRi pH module
TRi pH module POD pH sensor Buer soluon pH 7.5
Accessory bag (sensor holder, counterweight + securing
clip, PTFE tape and stoppers)
sucon + injecon hose
(5 meters)
Hole saw, 22 mm
1.2.2 TRi PRO module
TRi PRO module POD pH sensor ACL sensor Hole saw, 22 mm
Accessory bag (2 sensor holders, counterweight +
securing clip, PTFE tape and stoppers)
sucon + injecon
hose (5 meters)
Buer soluon
pH 7.5
Buer soluon
700 mV
1.3 Technical specicaons
TRi pH module TRi PRO module
Supply voltage Low voltage (connected to the TRi chlorinator)
Peristalc pump ow rate 1.8 L/h
Maximum back pressure (injecon) 1.5 bar
pH and ACL sensor type combined, epoxy body Ø12mm (pH = blue / ACL = red)
pH and ACL sensor electrolyte KCI polymer
pH and ACL sensor cable(s) 5 meters armored, BNC plug (pH = blue / ACL = red)
pH correcon acid (pH minus only)