H0412500.A - EN - 2013-02
4
EN
TRi pH module TRi PRO module
pH minus dosage Proporonal cyclic
pH sensor tolerances 5 bar / 60°C
Measurement scale & pH sensor accuracy pH 0.0 to pH 12.0, ± 0.1 pH
pH sensor calibraon 1 point, pH 7.5
ACL sensor tolerances / 5 bar / 60°C
Measurement scale & ACL sensor accuracy / 100 mV to 1000 mV / ± 10 mV
ACL sensor calibraon / 1 point, 700 mV
pH and ACL sensor response me < 15 seconds
Dimensions (w x h x d) 28.5 x 15.5 x 7.5 cm
Weight (module only) 1 kg
Protecon index IP23
2. Installaon
2.1 Preparing the pool: water balance
The TRi is designed to disinfect the water in the pool by means of its salt chlorinaon funcon.
With the TRi pH module, it automacally maintains the pH value of your pool.
With the TRi PRO module, it automacally maintains the pH value and chlorine level (ACL or Redox potenal) of your pool.
It is essenal for the water balance of the pool to be checked and adjusted before installing this equipment. Ensuring the
water balance of the pool is correct from the start will reduce the likelihood of encountering problems in the rst days
operaon or during the season using the pool.
Even if it is an automac control system, it is essenal to analyze the water regularly to check the water balance
parameters.
Unit
Recommended
values
To increase To decrease
Test frequency
(during season)
pH / 7.2 to 7.4
Deacvate dosage
or add pH+
Automac
(pH minus Perfect pH- or
pH-
Weekly
Free
chlorine
mg/L or ppm 0.5 to 2
Increase ACL set
point or add chlo-
rine
Decrease ACL set point
or turn o the unit
Weekly
TAC
(alkalinity or
buering power)
°f (ppm)
8 to 15
(80 to 150)
Add alkalinity cor-
rector
(Alca+ or TAC+)
Add hydrochloric acid Monthly
TH
(calcium hard-
ness)
°f (ppm)
10 to 30
(100 to 300)
Add calcium chlo-
ride
Add calcium binder
(Calci-) or decarbonate
Monthly
Cyanuric
acid
(stabilizer)
mg/L or ppm < 30
Add cyanuric acid
(only if necessary)
Parally drain the pool
and rell it
Quarterly
Salinity g/L or kg/m³ 4 Add salt
Leave as it is or parally
drain the pool and rell
it
Quarterly
Metals
(Cu, Fe, Mn…)
mg/L or ppm ± 0 /
Add metal binder (Metal
Free)
Quarterly