Zodiac TX20 - Default Chapter; Table of Contents

THANK YOU FOR PURCHASING THIS ROBOTIC POOL CLEANER BY ZODIAC
®
.
YOUR CLEANER HAS BEEN DESIGNED AND MANUFACTURED TO BE EASILY INSTALLED AND TO PROVIDE
LOW MAINTENANCE OPERATION. PRIOR TO INSTALLING YOUR NEW CLEANER, PLEASE DO THE
FOLLOWING:
1) Complete and return the warranty card.
2) Record your purchase information on the spaces provided below.
3) Attach your invoice (or a copy) to this page.
Taking these steps will help ensure prompt warranty service, should it be required. If service is required, please
contact your original dealer. If the original dealer does not perform warranty service:
Australia and New Zealand Please contact Zodiac Customer Care 1300 763 021 or visit www.zodiac.com.au
South Africa Please contact Zodiac Customer Care 0860 887 665 or visit www.zodiac.co.za
In the case that your product may require a warranty or service, please retain the original carton to transport your
cleaner in.
RECORD YOUR ZODIAC CLEANER DATA HERE:
Date of Purchase Purchased From Serial Number:
(located on machine head)
City State Postal Code
Section 1. Important Safety Instructions ........ 3
Section 2. Getting Started ................................ 4
2.1 GeneralSpecications ...................................... 4
2.2 Unpacking .......................................................... 4
2.3 Cleaner Control Unit ........................................... 4
2.4 Connecting to Power Source .............................. 5
Section 3. Operation ......................................... 6
3.1 Submerging the Cleaner .................................... 6
3.2 Running the Cleaner .......................................... 6
3.3 Stopping the Cleaner
and Removing from the Pool .............................. 7
3.4 Rinsing the Cleaner ............................................ 7
3.5 Cleaning the Filter Canister ................................ 7
3.6 Storing the Cleaner ........................................... 8
Table of Contents
Section 4. Maintenance .................................... 9
4.1 Cord Tangling
........................................................................... 9
4.2 Replacing the Brushes ....................................... 9
4.3 Replacing the Track .......................................... 10
Section 5. Troubleshooting ........................... 10
5.1 Using the Information LED ............................... 10
5.2 General Troubleshooting .................................. 10