Zodiac Vortex AV 348 50 - Removing the cleaner from the water

15
2.8 I Removing the cleaner from the water
• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.8.1 "LIFT SYSTEM" automated mode
The "Li System" funcon was designed to facilitate removing the cleaner from the water. It may be acvated at any
me, during or at the end of a cleaning cycle.
• If necessary, press and hold the buon
me, during or at the end of a cleaning cycle.
to direct the cleaner towards the required wall, the cleaner pivots.
When facing the right wall, release the buon. The cleaner moves towards the wall (see image ).
• Or just briey press the buon
When facing the right wall, release the buon. The cleaner moves towards the wall (see image
to move it towards the opposite wall (see image ).
• The cleaner climbs the wall and stays at the waterline (see image ).
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see
image ).
01'30''
2.8.2 Manually
• Switch o the appliance by pressing .
• Bring the cleaner to the edge of the pool by gently pulling on the oang cable.
• When possible, pick up the cleaner by the handle and li it gently out of the pool so that the water it contains drains
into the pool (see image and ).