Zodiac Vortex AV 348 50 - Electricity supply connection

8
❷ Use
2.1 I Immersing the cleaner in the pool
• Roll out the full length of the cable alongside the pool to avoid the cable becoming entangled during immersion (see
image
).
• Posion yourself halfway along the length of the pool before immersing the cleaner (see image
). This will opmise
the cleaner's movements and reduce tangling in the cable.
• Place the cleaner vercally into the water (see image
).
• Move it slightly in all direcons so that the air contained in the cleaner escapes (see gure
).
• It is essenal that the appliance sinks on its own and seles on the pool boom. While it is immersed, the cleaner
draws the length of cable it needs into the pool (see gure
).
Recommended entry point
not recommended
2.2 I Aachment to the base (depending on model)
EN