20
The remote control LED is fl ashing
slowly or the LED is steadily lit.
Remote control range problem:
• Posi on the control box on the caddy at least 3.5 metres from the pool.
• Orient the control box towards the pool in order to improve the range of the
remote control. Ensure there are no large obstacles between the control box
and the pool.
The remote control LED is steadily
lit.
• Synchronisa on problem: repeat the synchronisa on steps (see §”3.8.4
Synchronising the remote control with the control box”).
5.2 I User alerts
User alerts (depending on the model)
Solu ons
Flashing LED:
Error code:
Er: 10
• Check that the cleaner is correctly connected to the
control box. If necessary, unplug it and reconnect it
following the appropriate procedure.
Er: 02
Er: 03
Er: 05
Er: 06
• Check that there is nothing preven ng the brushes
and wheels from turning. To do so, turn the wheels
(1/4 turn) to release any debris that may be jammed.
Er: 07
Er: 08
• Cleaner opera ng outside the pool. Make sure you
start the cleaner when it is in the water (see § “3.3
Immersing the cleaner”).
Er: 01
Er: 04
• Check that there are no stones or hair in the propeller.
• Clean or change the fi lter if necessary.
5.2.1 Error codes
• Pressing a key deletes the error code and turns off the control box.
• The screen switches to standby a er 10 minutes. To turn the screen back on, press any key.
• When an error is detected, the control box temporarily suspends the programme (the LED is turned off ).
• Press and hold the key to revalidate the current programming.
EN
To Next Page
Loading...
Need help?
General
