CPR-D-padz
®
DEMO PAD
Figure 2 CPR-D Demo Pad Placement
Figure 1 Velcro Placement
1. Apply velcro loop strips to manikin as shown in Figure 1.
2. Place CPR-D Demo Pad on manikin as shown in Figure 2.
3. Demonstrate gel cover removal as shown in Figure 3 by holding the CPR-D pad with the
right hand and pulling the tab on the sternum pad with the left. Press sternum pad to
secure to manikin. Holding the CPR-D pad with the left hand, pull the apex tab with the
right hand to remove the gel cover. Press the apex pad to secure.
4. Attach green connector to AED plus and multi -function connector to Simulator.
Figure 3 Gel cover removal
R1345-106 Rev. E
ZOLL International Holding B.V.
Newtonweg 18 6662 PV ELST
The Netherlands Tel. +31 (0) 481 366410
®
ZOLL Medical Corporation
269 Mill Road
Chelmsford, MA 01824-4105 USA
800-348-9011 Made in USA
NOT MADE WITH
NATURAL RUBBER LATEX.
0123
32° F
0° C
50° C
122° F
0°C to 50°C (32°F to 122°F)
-30°C to 65°C (-22°F to 149°F)
0°C to 35°C (32°F to 95°F)
OPERATING TEMPERATURE:
SHORT TERM STORAGE TEMPERATURE:
LONG TERM STORAGE TEMPERATURE:
To Next Page
Need help?
General
