2 ZOLL M Series XL Battery
Charger Compatibility
The XL Battery is only compatible with ZOLL Base PowerCharger
4x4
or Base PowerCharger
1x1
units
labeled “XL Battery Ready.”
Older ZOLL Base PowerCharger
4x4
or Base PowerCharger
1x1
units may be upgraded.
All XL Battery ready chargers are backward compatible with the PD4410 battery pack.
Battery Maintenance
Test batteries regularly. At a minimum, ZOLL recommends testing batteries every three months. For
additional information on battery maintenance, refer to the ZOLL document, Battery Management
Program (#9650-0019).
Environmental Specifications
Operating Note
The XL Battery may feel warm to the touch following an excessive number of defibrillation
discharges at maximum energy.
Charge Time
The XL battery charge times are as follows:
Cleaning
Clean the ZOLL XL Battery with a soft damp cloth and mild soap.
CAUTION! Do not immerse or set battery in fluids; do not use alcohol, ketones
(MEK, acetone, etc.); and do not autoclave.
Upgrade Kits
M Series units with software version 20.00 and higher may be upgraded for use with the XL Battery.
If the unit is equipped with an Extreme Pack II, an upgrade will be required for the Extreme Pack as
well.
All M Series CCT units are compatible with the XL Battery.
Base PowerCharger
4x4
and Base PowerCharger
1x1
units not labeled “XL Battery Ready” must be
upgraded for use with the XL Battery.
Temperature
0°C to 50°C (operating)
15°C to 35°C (optimal battery charging)
-40°C to 70°C (storage)
Humidity
5% to 95% (relative humidity, non-condensing)
Charging Device Maximum Charge Time
M Series - unit plugged in and OFF 7.2 hours
M Series - unit plugged in and in use 43 hours
Base PowerCharger
4x4/1x1
Quick Charge
6 hours
Base PowerCharger
4x4/1x1
Auto Test 12 hours
Device to Upgrade Upgrade P/N
M Series (requires software version 20.00 or higher) 7777-0261
Extreme Pack II Call your sales representative
To Next Page
Loading...
Need help?
General
