Restoring Patch settings to the factory-set status (Re-Initialize)
Initialize is a special function which sets all the Patches and other settings of the 9000
back to the factory-set status. Note that when you carry out the initializing function, all
the Patches stored in memory will be deleted, and replaced back to the original factory
settings.
· In the Play mode, hold down the STORE key for ONE SECOND or more,
while holding down the EDIT/CANCEL key.
The contents of the display changes as shown in the following figure.
Displayed Items in the Initializing Standby Status
n To initialize all the Patches, - press the STORE key. “AL” on the display starts
flashing. Then press the STORE key again. (This operation can be canceled by
pressing the EDIT/CANCEL key).
n To stop the initializing operation at half way, - press the EDIT/CANCEL key.
This operation puts the 9000 back into the Play mode.
Helpful hint:
When the initializing function is carried out, calibration settings of the master volume
and the automatic tuning function reference pitch will also be set back to the factory-set
status.
23
To Next Page
Loading...
