Zoom 9000 - Page 27

26
g Effect Module 3: Modulation (MOD)
This Effect Module has 11 Effect Types which change tone in time.
n PITCH (Pitch)
This effect Type adds the effect sound with shifted pitch within a range of on octave
above, and/or one octave lower from the original sound, to the direct sound.
[Parameter]
(1) PIT (Pitch): -12 to +12
This parameter determines the difference of pitch at a chromatic
interval. The range which is settable is up and down to one octave.
(2) FIN (Fine): -10 to +10
This parameter adjusts finely the change of pitch.
(3) BAL (Balance): 0 to 10
This parameter determines the volume balance between the effect sound
and the direct sound. Setting to 0 outputs only the direct sound, while
setting to 10 outputs only the effect sound.
Helpful hint:
Setting the (PIT) to 0 and increasing slightly the fine (FIN) gives the chorus effect with
less modulation, to the sound.
n PHASE
This Effect Type adds the effect sound of different phases to the direct sound, and
changes that phase difference in time. A warm, straight tone which is different from
flanger or chorus can be obtained.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the depth of the phasing effect .
(2) RATE (Rate): 0 to 50
This parameter determines the waving speed of the phase.
n MID_EQ (Mid-range equalizer)
This Effect Type is a unique effect which uses a phasing effect as an equalizer. This
adds the effect sound of a different phase to the direct sound, and creates peaks and dips
in the frequency response. As a result, the sound in particular ranges is pronounced.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the amount of boost for the frequency to be
set with the following FREQ parameter.
(2) FREQ (Frequency): 0 to 50
This parameter determines the center frequency to be boosted.
(3) PEAK (Peak): 0 to 10
This parameter determines the range of the sound to be boosted. The
higher the value is, the narrower the range is set.