Functions added in Version 3.0
Input limiter
10
Input limiter (continued)
Setting the target level
When the limiter On/Off setting is set to On (Advanced), use
this to set the target output level for the signal.
5. Use e to select
Target
Level
, and press E.
6. Use e to adjust the setting,
and press m.
HINT
• This can be set from −16 to 0 dBFS.
• After a signal passes through the limiter, it will not exceed the set
target level value.
NOTE
This setting becomes available when On/Off is set to On (Advanced).
To Next Page
Loading...
