Functions added in Version 3.0
Input limiter
05
F
Multi Track Field Recorder
Attack
time
Threshold
Level
Input signal
Signal after
limiter
Release
time
Time
When the limiter is ON, if the input signal level exceeds the
set threshold value, the signal level will be suppressed to pre-
vent the sound from distorting.
The amount of time after the input signal exceeds the thresh-
old until compression of the output signal is maximized is
called the “attack time”. The amount of time after the input
signal goes below the threshold until the limiter stops com-
pressing the signal is called the “release time”. You can change
these two parameters to adjust the sound quality.
HINT
The F has a newly designed limiter that provides 10 dB of
headroom, allowing signals to be kept well below the set threshold,
therefore more effectively preventing distortion.
1. Press m.
2. Use eto select
INPUT
,
and press E.
3. Use e to select
Input
Limiter
, and press E.
4. Use e to select the input,
and press E.
HINT
Select
ALL
to set all the inputs at the same time.
Input limiter
In Version 3.0, advanced limiter was added. The limiter can prevent distortion by controlling input signals that have excessively
high levels.
To Next Page
Loading...
