7. Calibration completes.
8. To cancel calibration, press
m, and use e to select
Yes, and press E.
NOTE
• After calibrating once, the result will be retained.
• If the
F
is moved to and used in an extremely hot or cold loca-
tion, timecode precision could change slightly when the power is
turned off. In such cases, we recommend calibrating it again.
• Calibration is not possible when AIF with Rec is set to On.
• Calibration is only possible when Start TC mode is set to RTC.
• Calibration is not possible when an is connected.
Functions added in Version 3.0
Correcting timecode errors after the power has been turned off
18
Correcting timecode errors after the power has been turned off (continued)
Correcting timecode errors after the power has been turned off
To Next Page
Loading...
