Zoom G3 - Looper Functionality; Looper Activation, Recording Time, and Tempo

30
Using the Looper
Using the Looper
t 5VSO of the middle effect.
t 5VSO on the left effect.
1
To activate the Looper
2
To set the recording time
t 1SFTT for 1 second.
NOTE
t The looper can record 1.5–40 seconds (20 seconds when UNDO is enabled).
t *GUIFTFUUJOHOVNCFSPGRVBSUFSOPUFTXPVMEOPUGBMMJOUIJTSBOHF
it will automatically be adjusted.
t
Changing the recording time will erase the currently recorded loop.
NOTE
t 5IFTFUUJOHSBOHFJT
t $IBOHJOHUIFUFNQPXJMMFSBTFUIFDVSSFOUMZSFDPSEFEMPPQ
t
This tempo setting is used by every effect, rhythms and the looper.
3
To adjust the tempo
t :PVDBOBMTPTFUUIFUFNQPVTJOH
t *G OP MPPQ IBT CFFOSFDPSEFEZFU ZPV DBO BMTP TFU UIF UFNQPCZ
tapping .
HINT
Manual
Use the footswitch to start and stop recording.
Note mark
Set the recording time by setting the tempo and the number of
quarter notes.
TIME TEMPO
LOOPER LEVEL
SETTING