Zoom G3n - Using the Looper: Playback and Overdubbing; Loop Playback Control; Overdubbing Phrases

37
• Recordingstopsandloopplaybackstarts.
If the recording time is set to "MANUAL"
Loop playback will start when you press
again or when the maximum recording time is
reached.
If the recording time is set to a musical note
Loop playback will start when the set recording time is reached.
HINT
• SeeP39forhowtosettheLOOPERrecordingtime.
• Duringphraserecordingandplayback,switchingtoMEMORYmodewillnotinterruptit.
NOTE
• Duringrhythmplayback,recordingwillstartaftertheprecount.
• Changingapatchwillstopphraserecordingandplayback.Moreover,thiswilldeletethephraserecording
data.
• During rhythmplayback,quantizationis enabled so eveniftherecordingending time is notexact,the
loop will automatically be adjusted so that loop playback stays in time.
• ChangingthetempoofaRHYTHMduringloopplaybackwillerasetherecordedphrase.
■ Overdubbing a recorded phrase
• Duringloopplayback,press for the rst unit in the LOOPER.
■ Stopping loop playback
With 1-unit looper
• Duringloopplayback,press
twice for the unit using the looper.
• Thisstopstheplayback.
Using the looper