Zoom MULTISTOMP MS-100BT - Troubleshooting Common Issues; Power and Volume Problems; Noise and Battery Issues; Effect Malfunctions

35
NEXT
Troubleshooting
Troubleshooting
The unit will not turn ON
t 8IFOSVOOJOH POCBUUFSJFTDPOOFDUB DBCMF
to the INPUT jack to start the unit.
No sound or very low volume
t $IFDLUIFDPOOFDUJPOT
→
P8).
t
Adjust the levels of the ef fects being used
(
→
P10).
t $POmSNUIBUVOJUJTOPUJONVUFNPEF
→
P22).
There is a lot of noise
t $IFDLTIJFMEFEDBCMFTGPSEFGFDUT
t 6TFPOMZBHFOVJOF;00."$BEBQUFS
→
P8).
An effect is not working
t *GUIFFGGFDUQSPDFTTJOHDBQBDJUZJTFYDFFEFE
”DSP Full!” appears on the effect graphic. In
this case, the effect is bypassed (
→
P11).
Batteries lose their charge quickly
t $POGJSNUIBU ZPVBSF OPUVTJOHNBOHBOFTF
batteries. The continuous operation time is
about 7 hours with mono input and about 5
hours with stereo input when using alkaline
batteries.
t $IFDLUIFCBUUFSZTFUUJOH
→
P8).
Set the type of battery being used to enable
the rem aining charge to be shown more
accurately (
→
P23).
t %VF UP UIFDIBSBDUFSJTUJDT PG UIFCBUUFSJFT
they might be used more quickly in cold.