for a few seconds to indicate exclusion
If the first attempt is unsuccessful, please repeat the process following all steps carefully.
FACTORY RESET
When your network’s primary controller is missing or otherwise inoperable, you may need to reset the device to
factory settings manually. In order to complete the process, plug the Power Switch into a grounded receptacle, then
PRESS AND HOLD the Z-Wave button for AT LEAST 20 SECONDS. The LED indicator will flash orange and then
stay solid orange for 2 seconds to indicate successful reset. The Power Switch will then turn off.
NOTE: All previously recorded activity and custom settings will be erased from the device’s memory. You may only
reset your Power Switch once it has been in-cluded to a Z-Wave network.
ASSOCIATION
Depending on your Z-Wave gateway’s home automation software capabilities, you may be able to associate your
Power Switch in groups with other Z-Wave devices to schedule scenes and create events. This Power Switch
supports Group 1 with up to five devices for lifeline communication. This device will send BASIC REPORT to Group
1 when operated manually.
LED NOTIFICATIONS
The LED indicator on your Power Switch will visually report power consumption and network range.
How to read LED indicator colors?
Pink = Power Switch is off
Blue = 0 – 300 W
Cyan = 300 – 600 W
Green = 600 – 900 W
Yellow = 900 – 1200 W
Red = 1200 – 1500 W
Purple = 1500 – 1800 W
Purple blink = over 1800 W
LED Indicator Control
Parameter 27: You can choose how the LED indicator displays power consumption on the Power Switch
Values: 0 – LED indicator will display power consumption whenever the device is plugged in (LED stays on at all
times – default setting); 1 – LED indicator will display the level of power consumption for 5 seconds only whenever
the device is turned on or off (LED indicator will stay off for most of the time).
Size: 1 byte dec.
How to test Z-Wave network range for my Power Switch?
You can easily check if the Power Switch is within your Z-Wave controller’s range:
Press and hold the Z-Wave button for 6 to 9 seconds until the LED indicator turns violet. The LED indicator will then
report signal strength.
Flashing green = direct communication with the primary controller is established and still being diagnosed
Solid green for 2 seconds = direct communication with the primary controller is stable
Flashing orange = direct communication with the primary controller is intermittent and being diagnosed
Solid orange = communication quality is fair
Solid red = communication with the primary controller has failed
Press and release the Z-Wave button to exit testing mode.
This function may only be activated once the Power Switch has been included to a Z-Wave network.
To Next Page
Loading...
