Table Of Content
Unplugging the Power Cable 3
Unplugging the Extruder Cable 4
Unscrewing the Axis Block Covers, part 1 5
Unscrewing the Axis Block Covers, part 2 6
Extruder Removal 7
Lower Long Belt Replacement 8
Unscrewing the Belt Tensioners 8
Loosening the Screws on the Self-Aligning Bearings 8
Unscrewing the Self-Aligning Bearing, part 1 8
Unscrewing the Self-Aligning Bearing, part 2 8
Lower Long Belt Removal 8
Lower Long Belt Installation 8
Securing the Self-Aligning Bearing, part 1 8
Securing the Self-Aligning Bearing, part 2 8
Tightening the Screws on the Self-Aligning Bearings 8
Short Belt Replacement 15
Unplugging the Motor Cable 15
Unscrewing the Axis Motor 15
Axis Motor Removal 15
Unscrewing the Self-Aligning Bearing 15
Short Belt Removal 15
Short Belt Installation 15
Securing the Self-Aligning Bearing 15
Axis Motor Installation, part 1 15
Axis Motor Installation, part 2 15
Securing the Axis Motor 15
Extruder Installation 22
Securing the Axis Block Covers, part 1 23
Securing the Axis Block Covers, part 2 24
Securing the Belt Tensioners 25
Tightening the Screws on the Axis Block Covers 26
Tightening the Self-Aligning Bearing Screws 27