©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
40
1. Main
Activity Frequency Solution to problems Necessary accessories
Cleaning the machi-
ne, its interior and
surroundings, espe-
cially the bottom plate
under the platform
Before each printing The user is responsible for
keeping the machine clean.
To remove material rema-
ins from the interior of
the device, use a vacuum
cleaner or compressed air
- a vacuum cleaner,
- cleaning products with a high
evaporation rate
Cleaning the mother-
board and the power
supply unit from dust
using compressed air
Every 300 working
hours
Unscrew the bottom plate
and use compressed air to
remove dust
- a 2.5 Allen key,
- compressed air
Lack of proper care of the machine can cause inevident damage or improper operation of the drive
units.
!
To Next Page
Loading...
Need help?
General
