©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
41
Activity Frequency
Checking if the hotend and the nozzle are not clogged
and if they are clean from material residues
Before each printing
Cleaning the nozzle After nishing one spool of material
Checking if the screws that secure the heater and
thermocouple are tightened
Every 300 working hours
Lack of proper care of the machine can cause inevident damage or improper operation of the drive
units.
!
2. Hotend
To Next Page
Loading...
Need help?
General
