©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
42
3. Platform
Activity Frequency Solution to problems Necessary accessories
Cleaning the perfora-
ted plate
Before each printing To remove material re-
mains from the surface of
the perforated plate, use
a spatula
- a spatula
Checking the perfo-
rated plate for defor-
mation
Before each printing - -
Autocalibration Every 200 working
hours
If the platform autocali-
bration results vary signi-
cantly from one point to
another, move on to the
next activity indicated in
this table
-
Cleaning the heatbed
and the underside of
the perforated plate
Every 300 working
hours
Unscrew the screws that
secure the perforated
plate and remove the resi-
dues from the underside of
the plate using a spatula.
The heatbed needs to be
cleaned with a piece of
cloth damped in acetone
- a spatula,
- a piece of cloth,
- acetone
While cleaning the perforated plate, be careful not to damage the small connector placed at the edge
of the platform.
!
To Next Page
Loading...
Need help?
General
