zortrax M Series User Manual

©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
48
Error #031 Check the platform lar-
ge connector and restart the prin-
ter
No connection / short circuit be-
tween the heatbed and the heat-
bed cable
-Check the connection between
the heatbed and the heatbed cable
-Heatbed / heatbed cable replace-
ment
Error #032 Check the main extru-
der cable and restart the printer
No connection / short circuit be-
tween the extruder cable and the
extruder
-Check the connection between
the extruder and the extruder ca-
ble and restart the printer
-Extruder cable / extruder PCB re-
placement
Error #033 Check the perforated
plate contacts and restart the prin-
ter
No connection between the per-
forated plate and the heatbed or
short circuit on the perforated pla-
te (on calibration points)
-Check the heatbed cable for
proper connection
-Perforated plate / heatbed cable
replacement
Error #034 Check the endstops
and restart the printer
No signal from the endstops when
the extruder moves into the „home”
position (front left corner)
-Check the endstops for proper
connection
-Carry out X/Y axes maintenance
Error #040 Please, update the Fir-
mware to print
Z-SUITE blocks the printing pro-
cess for previous versions of rm-
ware due to safety reasons
-Update the rmware
Error #075 Please prepare the le
using a newer Z-SUITE version
Z-SUITE is not up to date -Update Z-SUITE to the latest ver-
sion and prepare the le again
Error #076 This zcode le was
exported for a dierent printer
model
The model has been prepared for
a dierent printer model
-Choose the proper printer model
while exporting the le in Z-SUITE
If the device begins to operate in an unidentied way, safely unplug the
printer from the power supply and immediately contact the Support
Center specialists via the support form at:
http://support.zortrax.com/support-form/.
While shipping the device to the Manufacturer’s technical service, it is
extremely important to properly pack the printer. Use the original pac-
kaging. Detailed instructions on how to pack the device are available at:
M200 http://support.zortrax.com/m200-packing/,
M300 http://support.zortrax.com/m300-packing/.
More manuals and tips & tricks articles are available at our Support Center.
www.zortrax.com

zortrax M Series Specifications

General

Brand	zortrax
Model	M Series
Category	3D Printers
Language	English